Configuration requirements for furniture paint room

The furniture paint room is dual-use and saves space. The roof of the paint booth is a two-layer air filtration system with three-dimensional rubber filter cotton. The following small series introduces you to the configuration of the furniture paint room.

1. The housing system of the furniture paint room: the wall board is made of polyethylene EPS insulation board, the wall board thickness is 50mm, the top board is assembled by bending high-quality galvanized steel plate; the door frame is made of professional open-die aluminum alloy profile, and the frame is used throughout the frame. Galvanized steel plate is fixed. The platform is assembled of galvanized steel and corrosion-resistant steel frame, and is equipped with two grilles and three tread plates. Two pieces of 600mm wide on the slope, the material is non-slip pattern plate.

2, air supply system: 2 sets of 4Kw double inlet air fan, air volume 2400m3 / h, air system 1 5.5Kw centrifugal fan, air volume 15000m3 / h, wind cabinet made of spray profiles, galvanized steel; The exhaust pipe is composed of high-quality galvanized steel plate and flange made of professional equipment. Loaded wind speed: 0.3 m / s; air exchange times: 240time / h.

3. Purification system: The initial effect of the air in the furniture baking room is high-quality filter cotton, which effectively captures dust particles larger than 10μm; the top high-efficiency filter is imported from Italy, which effectively captures dust particles larger than 5μm; the cotton wool is filtered into glass fiber. Cotton; TSP value: ≤1.4mg/m3.

4. Heating system: 24 sets of far infrared electric heating system.

5, high temperature: 80 ° C.

6, heating rate: 4 ~ 6min (20 ~ 60 ° C).

7. Fuel consumption: 4~6 Kg/set, total power 35Kw.

8, lighting system: top side lighting: 24 36W Phillips lamp. Illumination: 800Lux.

9, electronic control system: furniture paint room is assembled with high-quality electronic components, the main circuit is equipped with multiple protection; with temperature time setting, normal temperature painting, constant temperature painting, paint switch, lighting switch, stop switch, emergency stop switch, fault alarm, When accumulating.

10. Exhaust gas treatment: The exhaust gas is filtered by multi-layer activated carbon, and the exhaust emission of the furniture baking room reaches the standard.

At the same time, the furniture paint room is heated to the set temperature and kept at a constant temperature. After the hot air in the paint booth is saturated, it reaches a certain level, and the hot air in the paint is sent back to the fan for recycling.